The weathervane mounts and accessories shown in this category are for use only with SWEN products weathervanes.
This is an adapter sleeve to mount the ½” Swen rod in the ¾” hole in cupolas.
4 sided roof mount for SWEN Products vanes. Available in black and copper vein baked on powder coat finish.
Pole is made out of steel and is approximately 57" tall when assembled.
Roof mount is constructed out of steel; can be bent to any pitch. Size is approximately 10 inches wide; will fit 1/2 inch diameter pole.
Roof mount is constructed out of steel; can be adjusted 90 to match almost any surface.
Wind cups with bearing are made out of steel. Height is 1.5 inches and the width is approximately 8 inches; this includes a sealed ball bearing.
Threaded rod is approximately 17 inches tall and available with a 5/8 inch threaded or 3/4 inch threaded end.
Short pole is made out of steel, and is approximately 15 inches tall and will work with the roof mount. Available in black and copper vein baked on powder coat finish.
Weathervane Directional North South East West NSEW is made out of steel. There is a set screw to tighten the directional to the pole. Letters measure 2 3/4 inches high and approximate width is 11 inches.